Find the frequency source before swapping parts
The same harsh sound can come from a prop, commutation, a bearing or frame resonance. A description of how it sounds, without frequency and operating conditions, rarely supports a sound engineering decision.
An unusual sound is not automatically the motor
Multirotor noise is a sum of sources. The prop creates a passing frequency set by RPM and blade count, the motor adds electromagnetic components tied to slot-pole layout and commutation, bearings, gears and fasteners contribute mechanical frequencies, and the frame and mount amplify certain bands. What you hear may be dominated by one source — or by resonance between two parts.
Saying “sharp”, “low” or “harsh” is hard to reproduce. More useful: at which RPM it appears, whether it tracks load, whether it exists without props, where the peak frequency sits, and whether vibration or temperature rise comes with it. Frequency and conditions turn a subjective impression into a list of things to rule out.
If a periodic sound appears as soon as the motor spins without load, mechanical and electromagnetic sources deserve attention first; if it only appears with props and rising thrust, add prop balance, aerodynamic interference and frame vibration to the test. Establishing when it appears gets you closer than swapping the motor.

Narrow it down with controlled tests
Change one factor at a time. Measure at fixed RPM without props, with props, at different loads and with different mounts, logging microphone and vibration data. Keep position, distance and room reflections identical, or two runs of the same system cannot be compared.
A spectrum shows fundamental and harmonic relationships. Prop passing frequency scales with RPM, electromagnetic components track commutation and slot-pole layout, and bearing faults show characteristic ratios. Real systems have RPM ripple and structural coupling, so one peak proves little — but changing RPM and part combinations shows how peaks move.
Harness routing, prop orientation, screw preload and mounting face all affect results. Rule out looseness, damaged props and obvious balance problems before touching motor timing or ESC parameters. Record these basics so assembly differences are not mistaken for motor performance differences.
Start with the cheap, certain fixes
Noise work usually starts with props and mounting: replace damaged props, balance, adjust prop spacing and stiffen the motor mount — that quickly shows whether the cause is aerodynamic or structural. Then check bearing play, rotor balance, fastener condition and whether harness routing carries vibration into the frame.
On the electrical side, check motor timing, ESC switching frequency, control loop and RPM range. Some adjustments change the sound but also affect efficiency and temperature, so log thrust, current, temperature and noise with every change. Treating “quieter” as success can simply move the energy loss somewhere else. Acceptance criteria differ by mission: inspection platforms care about voice communication, manned aircraft about far-field sound pressure, indoor work about reflections in tight spaces. Measure at the relevant distance and condition, recording peak frequency, dominant direction and duration, so improvements can be repeated.